Tips and Tricks Caring Printer

Tips and Tricks Caring Printer

Below are a few tips I can give :

    Place the printer on a shady spot not too hot , not too humid or not placed in the wet.

1. Use the printer cover so protected from dust . 
2. Use the printer on a regular basis . Do not let the printer is not used at all in a long time . Use the printer to print out every other day at least 2-3 pieces . Neither the use for black and color ink . At least they always used so that the ink does not dry quickly . 
3. Immediately fill empty cartridges when the ink starts / runs using inks with the same brand . If using a different ink Catride must be empty . 
4. In doing Rechargeable / refile avoid touching the pin CMOS ( marked with a cross in the palm of the hand ) . The pin is very sensitive ( can be damaged ) due to static electricity from your body . 
5. Use a clean paper at least has a good quality with thick paper 60gram minimum . Do not use paper that has been worn and dusty . This could lead to a slip on the printer rollers . In addition it could cause dusty paper dust stuck to the Head . 
6. Clean dirty printer using a brush or wipe with a cloth . Special sections in use a small brush to be able to achieve the sidelines difficult . When cleaning make sure the printer is turned OFF or Dead total ( power cable unplugged ) . 
7. If your printer is often used ( typically for office ) do not often turn the printer on each finished ngeprint ... let the printer stays on . This is to minimize the Hit Counter Over the Counter Limit BIOS . All printers have a limited number of prints ( on average 2000 times ) . Each of us turn on the printer it will grow Counter (counts 1 time scoring ) . Imagine if during business hours ( eg 8 hours ) we turn off and turn on the printer up to 10 times or 20 times .... ? ! ! then it will accelerate we do RESET BIOS Counter on our printer .
8. Do not be too often print pictures / posts with high quality ( Hight Resolution ) will aggravate the Head that will automatically shorten Head . 
9. Infusion wear special printer , Ink Tank ... Put Infusion parallel ( rather low bit ) with Cartridge. This is to ensure that the ink does not flow directly into Cartridge when the printer is not in use. 
10. Clean / wash foam / sponge vacuum existing ink in the printer section at least once or 1 year if deemed suction power began to weaken . Usually characterized by ineffectiveness Dry Process Head or no ink spills inside the printer . If it is allowed to be harmful to electronic circuits / mechanical printer . In some cases the tricks used by removing the vacuum hose that goes and accommodated in a separate container .